700RB-II/1001RB-II Series
1001RB-II/700RB-II Series Combos
The 1001RB-II/700RB-II Series combos deliver the
1001RB-II/700RB-II?s unique features and distinct
sound by using a variety of internal speaker configu-
rations, GK?s RBH cabinet technology and a uniqueLock N? Roll Transport System:Combos
Lock N? Roll transport system.The Lock N? Roll transport system is designed for
quick and easy rolling of the combo on flat surfaces
Speaker Configurations:such as carpet, flooring, pavement, etc. To engage the
lock and roll handle, first move the combo into the
1001RB/115 or 700RB/115:upright position (front perpendicular to the ground).
One 8 Ohm 153speaker andNext, stand behind the cabinet, with your left hand,
one 8 Ohm horn.push the GK locking latch (below the handle) to the
1001RB/210 or 700RB/210:right, and lift the Lock N? Roll handle up with your
Two 16 Ohm 103speakersright hand. Let go of the locking latch and the
(wired in parallel for an 8handle will lock into place after about 1 1/2 feet.
Ohm equivalent load)andFinally, grab the handle and tilt towards the back of
one 8 Ohm horn.the combo. The wheels on the bottom of the cabinet
will automatically engage and allow smooth rolling.
The 1001RB-II/700RB-II combo electronics are
identical to the 1001RB-II/700RB-II head and areTo disengage the Lock N? Roll system, first return the
rated for the same maximum power output andcombo to its upright position and stand behind the
speaker load (700W/460W into 4 Ohms, and 480W/unit. Next, with your left hand, pull the locking latch
320W into 8 Ohms). Maximum power is achieved byat the base of the handle to your right, while pushing
connecting one 8 Ohm extension cabinet (such as thethe handle down gently with your right hand. Fi-
210RBH, 410RBH, or 115RBH) in addition to thenally, push the handle down until it stops and is flush
with the top of the combo. The handle will lock into
combo?s internal 8 Ohm speaker load. To drive more
than one extension cabinet, the combo?s internalplace.
speaker can be disconnected by unplugging the
Speakon cable connected to the combo?s back panel.The 1001RB-II/700RB-II Series combos are designed
for maximum setup versatility to accommodate a
Below is a detailed description of the maximum loads
the combos can drive.variety of playing situations. For practicing and close
monitoring situations, tilt the cabinet back into its
?Rock Back? position. For stronger bass and audi-
Maximum recommended load with theence projection, leave the combo in the upright
internal speaker connected:
One 8 Ohm cabinet on the Woofer/Main Amp.position.
One 8 Ohm horn on the 50W/Tweeter Amp.
Maximum recommended load with the
internal speaker disconnected:
One 4 Ohm, or Two 8 Ohm cabinets on the Main/
Woofer Amp.
One or Two 8 Ohm horns on the 50W/Tweeter Amp.
13 |
ACEC
